Philips TAFB1/10 - Troubleshooting Specific Features

29EN
EؽĚ׍ŊžĚÞŊüâēŏâŊġġŊüĚ½ęâġõŊüÿł
unit on my Bluetooth device
• Ensure the Bluetooth function is
activated on your Bluetooth device.
• Re-pair the unit with your Bluetooth
device.
Wi-Fi
Wi-Fi Connection cannot be established.
• üâØĐŊüâ½ŧ½ÿē½×ÿēÿŊŮġõ«W^
network on the router.
• Place the Wi-Fi router closer to the
unit.
• Make sure the password is correct.
• üâØĐŊüâ«W^õŏĚØŊÿġĚġľľâ×ġġŊ
the modem and Wi-Fi router.
Dolby Atmos
Cannot achieve outstanding Dolby
ŊęġłâŻâØŊł֣
• For non-HDMI connections (such
as use of USB, Bluetooth, Optical or
%EdE^ָ֤ēÿęÿŊâÞüâÿöüŊłŏľľġŏĚÞ
âŻâØŊł½ľâöâĚâľ½ŊâÞ֣ââŊüâ
section of ‘Dolby Atmos’ about how
Ŋġ½Øüÿâŧâ×âłŊ%ġē×ŮŊęġłâŻâØŊł֣
~ē½Ůֿž
½ĚĚġŊÞÿłØġŧâľŊüâ~ē½ŮֿžłŏĻĻġľŊâÞ
devices from the app.
• Make sure the device is connected to
the Wi-Fi.
½ĚĚġŊĻē½Ů~ē½ŮֿžęŏłÿØ֣
• Certain network service or contents
available through the device may
not be accessible in case the service
provider terminates its service.
• «üâĚŊüâžľłŊŊÿęâłâŊŏĻÿłĚġŊ
successful, close the Philips Sound
½ĻĻĻġŨâľâÞ×Ů%~ē½Ůֿž֣âłŊ½ľŊ
the app.
• When the speaker was set as Stereo
Pairs or Surround Sound, the speaker
need to be disconnected in the App
before use separately.
Remote control does not work
• Before you press any playback
ØġĚŊľġē×ŏŊŊġĚ֤žľłŊłâēâØŊŊüâØġľľâØŊ
source.
• Reduce the distance between the
remote control and the unit.
• Insert the battery with its polarities
(+/-) aligned as indicated.
• Replace the battery.
• Aim the remote control directly at
the sensor on the front of the unit.
üÿłÿł½ԛԟęÿĚłĻġŨâľġŻ
function, one of the ERPII standard
requirement for saving power
• When the unit’s external input
signal level is too low, the unit will
×âŊŏľĚâÞġŻ½ŏŊġę½ŊÿؽēēŮÿĚԛԟ
minutes. Please increase the volume
level of your external device.