Philips TDA8943SF - Revision history

Philips Semiconductors
TDA8943SF
6 W mono Bridge Tied Load (BTL) audio amplifier
Product specification Rev. 02 — 7 April 2000 17 of 20
9397 750 06865
© Philips Electronics N.V. 2000. All rights reserved.
18. Revision history
Table 11: Revision history
Rev Date CPCN Description
02 20000407 - Product specification; second version; supersedes initial version TDA8943SF-01 of
14 April 1999 (9397 750 04877). Modifications:
•
Table 1 on page 1: SVRR; Typ value 65 dB → added
•
Ordering options removed
•
Section 8 “Functional description”:
– Section 8.1 “Input configuration” on page 4 → added.
– Section 8.2 “Power amplifier” on page 4: ........, capable of delivering a peak output
current of 1.5 A → changed to 2 A.
– Section 8.2.1 “Output power measurement” on page 4 → added
– Section 8.2.2 “Headroom” on page 5 → added
•
Section 8.3 “Mode selection”:
– Standby mode: V
MODE
>(V
CC
− 0.5 V) → changed to (V
CC
− 0.5 V) < V
MODE
<V
CC
; The
power consumption of the TDA8943SF will be reduced to <0.18 mW → added.
– Mute mode: the DC level of the input and output pins remain on half the supply
voltage → added;
– 2.5 V < V
MODE
<(V
CC
− 1.5 V) → changed to 3 V < V
MODE
<(V
CC
− 1.5 V)
– Section 8.3.1 “Switch-on and switch-off” on page 5
•
Section 8.4 “Supply Voltage Ripple Rejection (SVRR)” on page 6 → added
•
Section 8.5 “Built-in protection circuits” on page 6 → added
•
Table 5 on page 6:
– P
tot
value added 7 W
– V
CC(sc)
value added 18 V
•
Table 6 on page 7:
– R
th(j-a)
value 65 K/W → changed 68 K/W
– R
th(j-c)
value 10 → changed to R
th(j-mb)
value 18 K/W
•
Table 7 on page 7: V
MODE
- mute mode - value Min 2.5 → changed to 3 V
•
Table 8 on page 8: SVRR; Typ values 65 and 60 dB → added
•
Figure 3 to 12: figures added
•
Section 13 “Internal circuitry” on page 11: → added
•
Figure 13: figure modified
•
Section 14.1 “Printed-circuit board (PCB)” on page 12: → added
•
Figure 14: figure added
•
Section 14.2 “Thermal behaviour and heatsink calculation” on page 14: → added
•
Section 15.2 “Test conditions” on page 14: → added
01 990414 - Preliminary specification; initial version.