32
Setting the time and date
If the display shows an incorrect time or '--:--', the time and date must be reset manually.
1 Press SYSTEM-MENU on the remote control. The menu bar
appears.
2 Select '
A
' symbol with D or C .
3 Select 'Installation' using CH- B or CH+ A and confirm with C .
4 Select 'Time/Date' using CH- B or CH+ A and confirm with C .
Installation
Time/Date
Time 20:00
Year 2003
Month 01
Date 01
To exit press
SYSTEM MENU
5 Check if the time in 'Time' is correct. If required, change the time
with the number buttons 0..9 on your remote control.
6 Check 'Year', 'Month' and 'Date' in the same way. To move between
the fields, use CH- B or CH+ A .
7 Check the displayed settings and confirm with OK .
'Stored' will appear briefly on the screen.
8 To end, press SYSTEM-MENU .
Installing your DVD recorder
To Next Page
Loading...
