Philips VideoPlus DVDR75 - Programming Recordings Without the VIDEO Plus+ System

65
Timer
VIDEO Plus+ system
Date
01
Prog.
BBC1
Start
20:15
VPS
PDC End
21:30
Rec
Mode
M2
Mo-Fr/Weekly
Press SELECT
To store
Press OK
6 The decoded data appears after confirmation. You can go back and
change the data. Select the appropriate input field with C or D .If
required, make changes using CH+ A , CH- B or the number
buttons 0..9 .
'Switching on 'VPS/PDC' in the 'Start' input field
Select the 'Start' input field using C . Using SELECT switch on 'VPS/PDC'
('*' lights up). If you press SELECT again, you will switch 'VPS/PDC' off ('*'
goes out).
Changing the recording mode in input field 'End'
Select the 'End' input field using C .
Use SELECT to select the recording mode 'M1, M2, M2x, M3, M4, M6'.
Tip
7 If all information is correct, press the OK button. The programming
information is stored in a TIMER block.
8 To end, press TIMER .
9 Insert a recordable disc (one without write protection).
The disk you have inserted will be checked.
0 Switch the DVD recorder off with STANDBY m .
The programmed recording will only function properly if the DVD
recorder has been switched off using the STANDBY m button.
If any of the TIMER blocks are in use, 'TIMER' will light up on the recorder display.
Programming recordings without the
VIDEO Plus+
®
System
1 Switch on the TV set. If required, select the programme number for
the DVD recorder.
2 Press TIMER on the remote control.
The programming method selected last is marked.
Timer
Timer programming
Date
01
Prog.
BBC1
Start
20:15
VPS
PDC End
21:30
Rec
Mode
M1
Mo-Fr/Weekly
Press SELECT
To store
Press OK
3 Select line 'Timer programming' with CH- B or CH+ A . and
confirm with the C button.
The information will appear on the screen.
4 Select the input field with D or C .
5 Enter information with CH- B or CH+ A or with the number
buttons 0..9 .
ENGLISH
Programming a recording (TIMER)