10
Tuner mode
You can also use your video recorder as a TV receiver
(tuner).
1 Hold the
STOP h
button, until + appears in the
display.
2 Choose the required programme number with the
P r
or
P q
button or with the
0-9
buttons.
3 Switch the video recorder to standby by pressing the
STANDBY m
button when you no longer want to watch
television.
Sound track selection
You can select the sound track. This is of particular interest
when the audio transmissions are multilingual.
1 Press the
SELECT
button. The current setting will appear
in the display. By pressing the
SELECT
button several
times you can select from the four possibilities displayed
(’STEREO’ ,’RIGHT’ ,’LEFT’ ,’MONO’ ).
Note: During playback you can select a fifth possibility:
the ’MIXED’ mode. In this mode you can play back the
mono sound of the normal (linear) audio track together
with the sound of the stereo audio track. This can be
used for playing back a recording dubbed on another
video recorder.
* If there is no stereo sound recorded on the cassette,
the video recorder automatically switches over to mono
sound.
Externally controlled TIMER recording
Do you have another device, e.g. a satellite receiver, which
can control other equipment by a Programming function?
This video recorder can be remote-controlled via socket
EXT.2
, by means of a scart cable.
1 Insert a cassette. Switch to standby with the
STANDBY m
button.
2 Hold the
MONITOR
button until ’REC.P’ appears in the
display.
3 If you want to interrupt this function before the recording
has actually started, hold the
MONITOR
button until the
video recorder switches to standby.
4 If you want to interrupt this function while a recording is
being made, press the
STANDBY m
button.
On Screen Display (OSD)
You can switch the On Screen Display (OSD) on or off.
1 Press the
AUTOINSTALL
button on the video recorder.
2 Select and confirm ’OSD’ .
3 Select and confirm ’ON’ or ’OFF’ .
Note: With the
OK
button you can superimpose the
actual operating mode on the TV screen.
Channel number or frequency display
You can switch between the display for ’channel number’ or
’frequency’ for manual channel search.
1 Press the
AUTOINSTALL
button.
2 Select and confirm ’CHANNEL/FREQUENCY’ .
3 Select and confirm ’CHANNEL’ or ’FREQUENCY’ .
4. SPECIAL FEATURES
To Next Page
Loading...
