Philips VR675/05 - Autoinstall; Setting the clock; Automatic Channel Allocation FOLLOW TV

4
Autoinstall
The video recorder will search for all TV programmes. It
stores TV programmes found in the following sequence:
BBC 1, BBC 2, ITV, CH 4, CH 5, SKY, others.
1 Press the
AUTOINSTALL
button on the videorecorder. If TV
channels have already been stored, select and confirm
the ’AUTOINSTALL’ line.
2 ’AUTOINSTALL’ starts.
AUTOINSTALL 00
3 Wait until all TV channels have been found. This can take
several minutes.
4 Autoinstall is now complete. Date and clock information
have been set.
If the clock time flashes in the display (e.g.:’20:00), read on in
the next section from step 3onward.
How to search for a TV channel manually, you read in
chapter 4 ’SPECIAL FEATURES’, the section about ’Manual
channel search’.
Note:
* If a TV channel transmits a ’TV channel name’ (e.g.
’BBC1’ ), it appears in the display.
Setting the clock
If a television programme which transmits TXT/PDC is stored
with programme number ’P 01’ , time (from TXT) and date
(from PDC) will automatically be taken from the TXT/PDC
information.
1 Press the
AUTOINSTALL
button on the videorecorder.
2 Confirm the line ’CLOCK’ .
3 Adjust ’TIME’ , ’YEAR’ , ’MONTH’ , ’DATE’ if required.
4 Confirm each entry.
Automatic Channel Allocation FOLLOW TV
With this function the video recorder maintains the same
programme sequence as on the TV set. This only functions if
the video recorder (socket
EXT.1
) and the TV set are
connected via a scart cable.
1 Switch on the TV set.
2 Press the
AUTOINSTALL
button on your video recorder.
3 Select the line ’FOLLOW TV’ and confirm with the
OK
button.
If the video recorder recognizes that the TV set has been
connected via a scart cable, ’TV01’ appears in the
display.
4 Select programme number ’1’ on the TV set .
5 Confirm using the video recorder-remote control. The
video recorder compares the TV channels on the TV set
and the video recorder.
If the video recorder found the same TV channel as the
TV set, then it stores it at ’P 01’ .
6 Wait until e.g.: ’TV02’ appears in the display.
7 Select, on the TV set , the next programme number,
e.g.: ’2’.
8 Confirm with the video recoder-remote control.
9 Repeat steps 6to 8until all TV channels have been
allocated.
To finish, press the
STANDBY m
button.
Note: If, at step 3’NOTV’ (no signal from TV set)
appears in the display, the TV channels can not be
allocated automatically. Then read further in chapter 4,
section ’Manual channel number allocation’.
* If you allocated the wrong TV-channel at step 5or
8you can go back one step with the
CLEAR (CL)
but-
ton.