5
1 Insert the cassette into the cassette slot.
2 Press the playback button
PLAY G
.
3 Picture scanning: Press the
H
(reverse) or
I
(forward) button once or several times.
4 Interrupt: Press the
STOP h
button.
5 Wind and rewind: Interrupt the playback function and
press the
H
(rewind) or
I
(wind) button.
0:20
If, during wind/rewind, you want to have a quick access
to picture scanning, use the ’Instant View’ function.
6 INSTANT VIEW: If you hold the
H
(Rewind) or
I
(Wind) button during wind or rewind, you will switch to
picture scanning. If you release the buttons, the video
recorder will automatically switch back to rewind or wind
again.
7 Eject a cassette: Interrupt the playback function and
press the
hSTOP/JEJECT
button on the video recorder.
Notes: Some functions switch off automatically after a
while (e.g.: Pause, Still Picture, Scanning). This helps to
protect the cassette and prevent unnecessary power
consumption.
* The picture quality will deteriorate during Picture
Scanning. The sound is turned off.
* With this set you can play back cassettes that have
been recorded on other video recorders in the NTSC
standard. This only works for television sets which are
suitable for a picture frequency of 60 Hz.
During NTSC-play back some special features (e.g. still
picture) are not possible.
Still picture/Slow motion
1 Press the
STILL R
button. A still picture appears on
the screen.
2 Each time you press
STILL R
again the picture will
move on one step.
3 Hold the
STILL R
button. The picture will be played in
super-slow motion.
4 Press the
I
button several times. You have a choice
of several playback speeds. When you press the
H
button several times you will return to the still picture.
There is no sound during slow motion playback.
Note: If the still picture vibrates vertically, hold the
P r
or the
P q
button at step 1until the vibration is
minimal. This setting will be stored automatically.
Please note, however, that interference may still occur
with poor quality cassettes.
Tape position/Index search
Tape position: The elapsed playback time, given to the hour
and minute, appears in the display.
When you load a cassette, the video recorder must first
calculate the playing time. Therefore, ’-:--’ appears first and
only after the tape has been running for a few seconds the
playing time will be shown.
The playback time displayed can be incorrect when using
camcorder cassettes or with cassettes made for NTSC-VHS
equipment.
Index search: At the beginning of each recording, the video
recorder marks the tape with a code mark. You can search
for these code marks on the tape. Once the video recorder
finds the code mark or a blank space it will automatically
switch to playback.
1 Press the
INDEX E
button and then press the
I
button to select the next code mark or the
H
button
for the previous code mark.
Note: You cannot use the function ’Index search’ with
recordings made on another video recorder that does
not have this code mark function.
2. PLAYBACK
To Next Page
Loading...
