WelcomeEye / Link / V1
F8
M. If your intercom panel is no longer ashing red, start a reset.
Click “Suivant” (Next). Your phone will now give a series of high-pitched signals.
Place your phone next to your intercom panel (having checked that the phone’s volume is
not too low)
The intercom panel will ash blue, remain stable, then go out.
N. Now name your device and choose the type of detection message you wish to receive.
Please note, if you want to receive when the alarm is triggered, you must select the “alert
notication” banner and dene the message type by pressing
“ ” .
Without this information, you will not receive detection alarm notications or emails on
your phone.
Warning: the motion detection mode signicantly reduces the battery life.
If you are not interested in presence detection, skip this step by “validating” in the rst
window.
Choose the room that will be linked to your videophone. “ ” allows other possibilities.
To Next Page
Loading...
