Table of contents
7982_en_07 PHOENIX CONTACT 5 / 148
7.7.6 Jumpers in the power connectors, potential forwarding, and fusing ..... 74
7.7.7 Parallel supply ...................................................................................... 75
7.8 Connecting the network....................................................................................... 75
7.9 Connecting the USB cable to the micro USB interface ........................................76
7.10 Connecting sensors and actuators ...................................................................... 77
7.10.1 Connection technology for sensors and actuators ............................... 77
7.10.2 Connections used for low-level signal digital I/O modules ................... 78
7.10.3 Connecting digital sensors and actuators using the different
connection technologies ...................................................................... 79
7.10.4 FLK ...................................................................................................... 82
7.10.5 Redundant signals ...............................................................................83
8 Grounding and shielding...........................................................................................................85
8.1 Grounding concept..............................................................................................85
8.1.1 Protective earth ground (PE) ................................................................ 85
8.1.2 Functional ground (FE) ........................................................................ 86
8.2 Shielding concept................................................................................................ 87
8.2.1 Shielding with Axioline F ...................................................................... 87
8.2.2 Shielding when connecting analog sensors and actuators ...................87
8.2.3 Connecting the shield using the Axioline F shield connection set ........ 88
8.2.4 Connecting the shielding to a busbar ...................................................92
8.2.5 Integrating analog shielding in a concept with central equipotential
bonding at the control cabinet entry ..................................................... 93
9 Diagnostic and status indicators ...............................................................................................95
9.1 Indicators on controllers ......................................................................................95
9.2 Indicators on bus couplers................................................................................... 96
9.3 Indicators on I/O modules....................................................................................98
9.3.1 LEDs on the power connectors ............................................................ 98
9.3.2 LEDs on the I/O connectors ............................................................... 100
9.4 Reporting diagnostics via PDI............................................................................100
10 Process, parameter, and diagnostic data................................................................................101
10.1 Process data .....................................................................................................101
10.2 Parameter and diagnostic data (PDI channel) ...................................................101
10.3 Saving of parameters ........................................................................................ 103
11 Software support ....................................................................................................................105
11.1 Overview of the software ...................................................................................105
11.2 Planning and configuration: PROJECT complete .............................................. 105
11.3 Startup and parameterization:
FDT/DTM and Startup+ ..................................................................................... 106
To Next Page
Loading...
Need help?
General
