Phoenix M48-S - Page 17

Unifarm Machinery Corporation
PO Box 38, Wilson, NC, U.S.A.
page 17
picture 7
Every 20 working hours
- lubricate the pulley support bearing (C –
picture 9).
Every 30 working hours
- check belt tensioning.
Every 40 working hours
- lubricate the wheel supports (A –
picture
8).
After the first 50 working hours and, later,
every 800 working hours
-
replace the oil in the gearbox. Use oil SAE
EP 80W90.
Contact the closest Unifarm dealer for this maintenance activity.
picture 8 picture 9
The old oil must be disposed of in compliance with local laws
where these activities are carried out; do not spill or dispose
of waste oil on the ground.
The maintenance activities must be carried out with the
engine off, the power take off disengaged, the parking brake
engaged, and the equipment placed on the ground.