Phoenix M48-S - Blade Replacement; Spare Parts

Unifarm Machinery Corporation
PO Box 38, Wilson, NC, U.S.A.
page 18
BLADE REPLACEMENT
picture 10
For perfect machine operation, frequently check the lawn
mower blades: make sure that they are sharp and perfectly
anchored by means of the bolts. Follow the procedu
re below
to replace the blades:
- Adopt any measures to prevent accidental machine start-
up.
- Place the equipment on sturdy supports.
-
Remove the screws anchoring the blades as shown in
picture; remove the old blades and install the new ones.
Before replacing the blades, turn the tractor engine off, pull
the parking brake, disengage the power take off, raise the
mower using the tractor lift, and install supports to prevent
accidental dropping of the machine.
SPARE PARTS
Always use original Unifarm spare parts for the best lawn mower performance.
For spare parts requests please refer to the spare parts catalog.
The spare parts can be ordered from the dealer or service center. The following data must always be
specified:
- Equipment type and width.
- Part number of the requested component. If the code number is missing, indicate the table
number in which it is shown and the relevant reference.
- Description of the part and requested quantity.
- Requested type of transport. Should this information not be provided, the dealer or service
center shall not be responsible for delays caused by circumstances beyond their control. The
addressee shall be responsible for any transport charges.