Unifarm Machinery Corporation
PO Box 38, Wilson, NC, U.S.A.
page 8
IDENTIFICATION PLATES
The identification plates are placed on all the mowers and are structured as follows:
Model of mower (example): Serial number (example):
When asking for information or service, always specify the
machine type and the width.
RECOMMENDED USE
The mowers of Unifarm Machinery Corporation, described in this instruction and maintenance
manual, have been designed explicitly to till the land. Any other use jeopardizes the operator’s
safety and the machine integrity.
INAPPROPRIATE USE
Phoenix mowers shall not be used as follows:
- Connected to vehicles which do not have a suitable power or weight.
- Without being properly installed by securing the hitch blocks to all three points of the tractor lift
unit.
- Mowing of extremely stony or unsuitable ground.
- Raising or lifting of the equipment when the power take off is engaged.
- In close proximity to person/s when power is engaged.
- Do not stand or step on the equipment when it is being operated or transported.
- Do not operate the machinery while wearing unsuitable (loose fitting) clothing.
TORQUE SPECIFICATION
For correct hardware tightening on the tiller, we suggest the use of suitable torque wrench and the
applicable torque as listed in the table below:
M-THREADED SCREW/BOLTS
Bolt grade
8.8 10.9
Thread
Nm Lb-ft Nm Lb-ft
M6 11 8.5 17 12
M8 28 20 40 30
M10 55 40 80 60
M12 95 70 140 105
M14 150 110 225 165
M16 240 175 305 225
M18 330 250 475 350
To Next Page
Loading...
Need help?
General