Unifarm Machinery Corporation
PO Box 38, Wilson, NC, U.S.A.
page 16
ROAD TRANSPORT
With reference to road transport, follow local traffic regulations.
SHUT DOWN
The following activities are recommended if the tiller will not be used for a long period of time:
- Clean and dry the equipment.
- Inspect the equipment and replace the damaged or worn parts if necessary.
- Tighten all the screws and nuts.
Lubricate and cover the machine with a tarpaulin and store it in a dry place.
MAINTENANCE
Maintenance is crucial for the working life and efficiency of any agricultural equipment. If the
equipment is properly maintained and operated, a long working life and operator safety are assured.
The maintenance intervals indicated in this booklet are provided as a mere reference and are related
to normal working conditions; changes may occur depending on the type of activities, environmental
dust, seasonal factors, etc.
- Before injecting lubricating grease into the grease
fittings, clean the fittings to prevent mud, dust, or any
other foreign matter from contaminating the grease and
reducing the lubrication effect.
- When adding or changing the oil, use the same type of oil
to prevent mixing oils with different features.
- All maintenance activities must be carried out with the
tiller resting horizontally on the ground, with the engine
off and not overheated.
- After using the equipment for a few hours, make sure
that all the bolts (especially tine bolts) are tightened;
regularly check all the machine guards.
PROGRAM
First check
- after 50 working hours, check the oil in the gearbox (A – picture 7) and make sure that all the
screws and bolts are tightened.
To Next Page
Loading...
Need help?
General