Phoenix PWB-1535A User Manual

Phoenix Auto Equipment
-Address: 2711 East Craig Road Ste #E, North Las Vegas, NV, 89030 United States
- Website: https://www.phoenixautoequipment.com
- Phone: 7025802883
23 / 24
the wheel is spinning.
Err 02
Rotating speed is too
low for machine to
work.
Tighten the drive belt.
Check to make sure the
spin shaft is tight and
properly spinning.
Check to make sure the
motor is functioning
properly. Put a heavier
wheel. The machine is
for balancing full size
car and truck tires, not
TV or smaller tires.
Err 03
The rotation is in the
wrong direction.
Occurs when using a 3
phase motor. Adjust
the three phase wires.
ERR CAL
The machine is not
calibrated
Follow the calibration
steps.
ERS CAL
Factory Maintenance
Error
Contact the
manufacturer
Machines Continues to
ask for more weight
Machine is not properly
calibrated, wheel
parameters where
parameters where not
entered correctly, or
weight sensor board is
defective
Calibrate the machine
properly. Enter wheel
parameters correctly
(remember that when
the machine is turned
off, the wheel
parameters are not
saved). Check weight
sensor board for
broken parts or loose
wires.
Machines trips
electrical breaker
Transformer or Power
Board are defective
Replace the power
board or transformer
Machines seems to
overheat and shut
down automatically
Transformer is
overheating or power
board is defective
Check temperature of
transformer at the time
the machine shuts

Phoenix PWB-1535A Specifications

General

Brand	Phoenix
Model	PWB-1535A
Category	Wheel Balancers
Language	English