Phoenix Auto Equipment
-Address: 2711 East Craig Road Ste #E, North Las Vegas, NV, 89030 United States
- Website: https://www.phoenixautoequipment.com
- Phone: 7025802883
17 / 24
After placing the weight, close the hood and spin the wheel. The
machine will beep and you will see the following screen for a short
time:
After showing this screen, the machine will automatically return to
the initial balancing screen. You have successfully calibrated the
machine and the data was saved automatically.
Please note that if you do not put a wheel weight on the rim, the
machine will not calibrate. You will cause the machine to “chase itself
to infinity” when trying to calculate the calibration. The resulting
screen will look like this:
If you see this screen, you did not calibrate it correctly. Turn off the
machine and try again.
8. Standard Dynamic Mode
After completing the steps above, you are now ready to balance.
Standard Dynamic mode is for balancing steel wheels by placing clip on
To Next Page
Loading...
Need help?
General