•l Troubleshooting
Issue
Print
Quality
Issues
Problem
Myprint is
poor quality?
Reason
(I)Cover is not
completely closed
(2)Poorquality of
label paper
(3)Marginsand
paper size
Solution
Firmly pressthe Cover to confirm that it hasbeen
completely closed.
The darkness of the label depends on the label
manufacturer. High quality labels produce darker prints.
Pleasemake surethe label size iscorrect before printing.
Ifthe content exceedsthe label size,the printer may
"shrink" the sizeto a smaller size resulting in faded
content.
NOTE:If you are printing4 x 6 inches labels, the sample
4 x 6 inches label from Phomemo website should take
up the full width and height of your label.
Follow FAQ'ssteps from Phomemo website to adjust
(4)Printdensityandprintdensityandspeedoncomputer.
NOTE:Setting the density too high may cause some
speed
unwanted dark lines and/or the label getting too hot and
sticking to the Printhead.
Turn off printer. Openthe Coverand usethe alcohol pads
to wipe the Printhead and Platen Roller clean.(Any70%
Alcohol pad would work.) Allow 2-3minutes for
(5)Dustor adhesive
components to dry, then closethe Coverand turn Label
on the printhead
Printer back on.
NOTE:Firmly pressthe Coverto confirm that it hasbeen
completely closed.
Turn off printer. Openthe Coverand usethe alcohol pads
to wipe the Printhead and Platen Roller clean.(Any70%
Alcohol pad would work.) Allow 2-3minutes for
Why are there
Dust or adhesive on
white spots
the printhead
on label?
components to dry, then closethe Coverand turn Label
Printer back on.
NOTE:Firmly pressthe Coverto confirm that it hasbeen
completely closed.
08
To Next Page
Loading...
