Phonak ComPilot II - Pairing ComPilot II with Devices; Pairing with the TVLink II; Pairing with the RemoteMic

Connecting to Computers/Tablets
WIRED IN (3.5 mm cable)
1. Switch ON your ComPilot II and place it around
your neck with your hearing aids on. Figure 1
2. Insert the audio cable into your
ComPilot II. Figure 2
3. Insert the other end of the audio cable into
the headphone socket of your audio device
(Computer/Tablet/Phone). Figure 2
4. Start the audio on your computer/tablet/phone
and the audio streaming will automatically start.
WITH YOUR TVLINK II
1. Ensure your TVLink II is paired with your
ComPilot II. For pairing instructions
CLICK HERE (see page 20-23)
2. Remove your TVLink II from your television,
if it has already been set up there, and
insert the 3.5 mm analog audio cable in
the back of the TVLink II. Figure 3
3. Insert the other end of the audio cable into
the headphone socket of your audio device
(Computer/Tablet/Phone). Figure 3
4. Ensure the TVLink II is plugged into a
power supply and turned on. Figure 4
5. Turn on your ComPilot II and place
it around your neck. Figure 1
6. Start the audio on your computer/tablet/phone
and the audio streaming will automatically start
AUDIO
Figure 1
Figure 2
Figure 3
Figure 4