Phonic Ear hearlt all - Setup; Wireless Setup Overview

Charging when travelling
1. Connect Y-cord to the power supply and ensure that the power supply is
correct connected to an active wall power outlet.
2. Connect the ends of the Y-cord to charging jack T4 on transmitter and/or
charging jack R11 on the receiver.
3. Receiver indicator R5 and transmitter indicator T1 will illuminate red while
charging.
4. Once charging is complete, receiver indicator R5 and transmitter indicator
T1 will light green.
Operation
Operation
Listening to the television
Using HearIt All with your television
1. Place the receiver around neck (see page15).
2. Turn on the receiver by pressing receiver button R1 for up to five seconds.
3. Place the transmitter firmly in the charger.
4. Turn on the transmitter by a single short push to transmitter button T1.
5. Transmitter indicators T2 and T3 will both illuminate white indicating
transmission.
6. Receiver indicator R1 will illuminate white while listening to the television.
R1
T1
R1
T3
T2
2
43
6
5
1918
-
+
T4
R11
3
4
2
1
*
Charged
Please note:
As the battery capacity of the receiver is larger than the battery capacity of •
the transmitter it may take slightly longer to charge the receiver.
We recommend fully charging batteries before use, however, partly charging •
the units does not inflict damage to them.
Please note:
If there is no sound press receiver button • R2+ (volume up) for 5
seconds to activate the wireless connection.
* Plugs vary from country to country