Phonic MAX 3500 - Specifications and Support; Technical Specifications

7
English
MAX 3500
SPECIFICATIONS
Stereo Mode
(driving both channels)
8Ω EIA 1kHz 0.1%THD 1600W
4Ω EIA 1kHz 0.1%THD 2400W
Bridge Mono Mode 8Ω EIA 1kHz 0.1%THD 4800W
System
Output Circuitry Class H
Input sensitivity @ 8Ω 1.42 Vrms
Distortion (SMPTE-IM) <0.02%
Noise (unweighted 20 Hz
- 20 kHz below rated output)
107 dB
Damping Factor >500 @ 8Ω
Frequency Response 20 Hz-20kHz +0/-1dB; -3dB points: 5Hz-50kHz
Input Impedance 20 kΩ balanced; 10 kΩ unbalanced
Cooling
Continous variable-speed fan - rear-to-front air
ow
Indicators Power; Signal; Peak
Controls
Front panel AC power switch & Gain knobs
Rear panel
HPF; Clip; Limiter; Operating Mode; Circuit
Breaker; Grounding/Floating
Operating Modes Parallel; Stereo; Bridge Mono
Voltage Gain 40 x (32 dB)
Connectors (each channel)
Input XLR & 1/4” TRS
Output Binding post & Speakon
Subwoofer Output Crossover 60 Hz; 90 Hz; 120 Hz
Protection Circuitry
Amplier Protection
Full short circuit / Open circuit / Thermal
/ Ultrasonic / RF protection / stable into
mismatched loads
Load Protection
On/off muting / AC coupling / Triac crowbar
(each channel)
Power Supply
Power Consumption 1000W
Power Requirement
(depends on region)
100~120VAC - 220~240VAC - 50/60Hz
Physical
Dimensions (mm) 482.6 x 133.5 x 376 mm
Dimensions (inches) 19” x 5.25” x 14.8”
Weight (kg) 20.3 kg
Weight (pounds) 44.8 lbs