Need help?Do you have a question about the Phonic XP 5000 and is the answer not in the manual?
General| Power Output (4 Ohms Bridged) | 3200W |
|---|---|
| Signal to Noise Ratio | > 100dB |
| Cooling | Variable speed fan |
| Input Impedance | 20 kΩ Balanced, 10 kΩ Unbalanced |
| Connectors (Input) | XLR and 1/4" TRS |
| Channels | 2 |
| Damping Factor | > 300 |
| Total Harmonic Distortion | <0.03% |
| Input Sensitivity | 1.4V |
| Dimensions | 483 x 451 x 88 mm |
| Connectors (Output) | Speakon and Binding Post |
| Protection | Thermal, short circuit, DC, overload |
| Frequency Response | 20Hz - 20kHz (±0.5dB) |
Guidance on rack mounting, airflow, space requirements, and the amplifier's cooling system.
Explanation of input/output connectors (XLR, TRS, Speakon) and wiring methods.
Explanation of CLIP/LIM, PROTECT, and SIGNAL indicator lights.
Details on gain adjustment knobs and the main power switch.
Description of LEDs indicating Bridge Mono or Parallel mode operation.
Controls for subwoofer frequency output and filtering options.
Covers input/output connectors, power cord, reset breaker, and grounding.
Details on the grounding/floating switch for managing ground loops.
Switches for activating peak limiter and 30/50Hz high pass filters.
Explanation of mode selection switches and procedures.
Detailed continuous average output power ratings for various impedance loads.
Specifications including input sensitivity, distortion, damping factor, and frequency response.
Information on input impedance, cooling, connectors, controls, protection, and dimensions.
Contacting distributors for parts, service, and advice against self-repair.
Details on the limited warranty coverage, terms, and conditions.
Resources for FAQs, tech tips, downloads, and contact information.
Detailed physical dimensions for different XP series amplifier models.
Schematic representations of the internal circuitry and signal flow.
To Next Page
