Need help?Do you have a question about the Phonic DMX2501 and is the answer not in the manual?
General| S/N Ratio | > 100 dB |
|---|---|
| Connectors (Input) | XLR and 1/4" TRS |
| Frequency Response | 20 Hz to 20 kHz, +0/-0.5 dB |
| Input Impedance | 20 kOhms balanced, 10 kOhms unbalanced |
| Protection | Short circuit, DC, overload |
| Connectors (Output) | Binding posts and Speakon |
| Cooling | Fan-cooled |
Describes how to install the amplifier in a standard 19" equipment rack.
Explains the cooling requirements and airflow management for the amplifier.
Details the input and output connector types and wiring configurations.
Explains the function of the power switch and recommended powering up procedure.
Describes the signal indicators for each channel, showing audio signal reception.
Explains the peak limiter LEDs, indicating clipping or potential faults.
Details the function of the gain control knobs for adjusting channel levels.
Mentions the blue LED that indicates when the amplifier is powered on.
Describes the XLR and TRS input connectors and their acceptance of line-level signals.
Explains the DIP switches for activating limiter and setting operation modes.
Details the low-cut filter options and how to activate them via DIP switches.
To Next Page
