POWERPOD408 USER’S MANUAL
PHONIC CORPORATION
Page 8
REAR PANEL DESCRIPTION
REAR PANEL DESCRIPTION
11 POWER SWITCH
This switches the powered mixer on and
off. While turn it on, the power on blue LED
indicator will light up on the master section
of front panel.
12 SPEAKER OUTPUT JACKS
Speakers can be connected to these sock-
ets, two speakers can be connected to the
pow ered mixer. When using 2 speakers at
the same time, use 8~16 ohms speakers.
When us ing one speaker only, use a 4~8
ohms speak er. The total minimum required
load is 4 ohms. If the total load is less than
4 ohms, it may dam age this pow ered mixer.
13 MAIN OUT / AMP IN
This unbalanced insert point is a break be tween the main
out and built-in amplifi er to allow the main output to be
sent to an external signal processor or power amplifi er.
The in sert is a 1/4
’
phone jack socket which is nor mal ly
by passed. When a jack is inserted, the signal path is
broken.
The main output signal appears on the TIP of the plug and
the external signal is returned on the RING. A
“
Y
”
lead
may be required to connect to equipment with separate
send and return jacks as shown below:
To Next Page
Loading...
