72
DC Power Cord
The 2020PROPlus can be connected to a car battery through the cigarette lighter
with the DC power cord. While the 2020PRO
Plus is connected to the car battery, the
2020PRO
Plus battery is being charged.
NOTE: The 2020PRO
Plus is not classified for use in hazardous locations with a DC power
cord.
To connect the 2020PROPlus to a DC power supply:
1. Turn the instrument off by pressing the ON/OFF key for five seconds.
2. Connect the DC power cord (Part No.MX350004) to the 2020PRO
Plus
AC adapter jack on the rear of the instrument.
3. Connect the other end of the DC power cord to the cigarette lighter in
the car.
4. Turn the instrument on again by pressing the ON/OFF key.
If the vehicle is running, ensure the engine exhaust does not contaminate your
samples.
Belt Clip Holster
Use the belt clip holster (Part No. MX750011) to protect the instrument and to
mount the instrument to a belt.
To Next Page