Specifications
LIFEPAK 1000 Defibrillator Operating Instructions A-5
©2018 Physio-Control, Inc.
Shock Ready Times
Electrical Protection: Input protected against high voltage defibrillator pulses per
IEC 60601-1. See Figure A-1.
Figure A-1 Defibrillation–proof type BF applied part
Safety Classification: Internally powered equipment. IEC 60601-1
AED Mode
Shock Advisory
System:
ECG Analysis system that advises whether a shock is appropriate,
meets rhythm recognition criteria specified in DF80 and IEC
60601-2-4. In AED mode, the device allows a shock only if
Shock Advisory System advises defibrillation.
Energy Sequence: Multiple levels, configurable from 150 to 360 joules
Shock-to-Shock
cycle time (200J to
300J):
Less than 25 seconds
Time for a 3-shock
sequence
(200J/300J/360J):
Less than 70 seconds
Manual Mode
Energy Sequence Delivers energy at levels selected in Setup mode.
Timing
Parameter
200 Joules 360 Joules Comments
Analysis time Less than 10
seconds
Less than 10
seconds
Analysis time applies if no motion is detected.
If the device detects motion, analysis may be
delayed by up to 10 seconds.*
Defibrillator
charge time
Less than 9
seconds
Less than 15
seconds
Applies for a new fully charged battery or after
15 full energy discharges.
Power on to
shock ready time
(Manual mode)
Less than 20
seconds
Less than 25
seconds
Applies for a new fully charged battery or after
15 full energy discharges.
Analysis initiation
to shock ready
time (AED mode)
Less than 25
seconds
Less than 30
seconds
Applies for a new fully charged battery or after
15 full energy discharges.
Power on to
shock ready time
(AED mode)
Less than 25
seconds
Less than 30
seconds
Applies for a new fully charged battery or after
15 full energy discharges.
*Device behavior may vary for Arabic, Finnish, Icelandic, and Slovenian.
To Purchase, Visit Avobus.com or call 1-800-674-3655
To Next Page
Loading...
