Need help?Do you have a question about the Physio Control LIFEPAK 500 and is the answer not in the manual?
Lists registered and common law trademarks used in the manual.
Provides contact information for Physio-Control Inc. and its international offices.
Outlines prerequisites for cleaning/repair and how to contact service.
Directs users to setup/operation instructions and contacts for warranty service.
Defines terms used throughout the service manual.
Defines specific terms like Danger, Warning, Caution, and Note used in the manual.
Lists general warnings and cautions for AED use and handling.
Explains symbols used in the manual and on the AED for safety and identification.
Details the AED's components, models, and feature options.
Describes the main components and their functions within the AED.
Explains the conditions required for the AED to operate in Normal Mode.
Lists user-accessible and service-accessible setup options for the AED.
Describes automatic tests performed by the AED for performance checks.
Lists functions accessible to qualified personnel via the front panel in Service Mode.
Describes how to perform complex internal tests using PC software.
Explains how the AED logs and categorizes fault codes.
Lists codes and their corresponding corrective actions for resolving faults.
A comprehensive table listing fault codes and their recommended corrective actions.
A chart mapping observed problems to suggested corrective actions.
Outlines a schedule for inspection, testing, and cleaning the AED.
Provides guidelines for maintaining both rechargeable and nonrechargeable batteries.
Describes procedures for cleaning the AED's interior and exterior.
Step-by-step instructions for safely discharging the AED's energy storage capacitor.
Procedures for saving AED setup configurations before service.
Procedures for replacing the AED's outer case assemblies.
Steps to remove the Main PCB from monophasic AED units.
Instructions for replacing the Main PCB in monophasic AED units.
Steps to remove the Energy Storage Capacitor from monophasic AEDs.
Instructions for replacing the AED's speaker assembly.
Instructions for replacing the wave shaping inductor in monophasic AEDs.
Instructions for replacing the patient connector harness in monophasic AEDs.
Explains part numbering schemes and the role of the Parts Configurator.
Interactive tool to identify parts based on unit configuration.
Lists service kits and their included components for various AED parts.
Describes how to use assembly diagrams to identify AED components and part numbers.
General| Operating Temperature | 0°C to 50°C (32°F to 122°F) |
|---|---|
| Storage Temperature | -4°F to 140°F (-20°C to 60°C) |
| Heart Rate Display | Yes |
| Display | LCD screen |
| Monitoring | ECG monitoring via electrodes |
| Type | Automated External Defibrillator (AED) |
| Defibrillator Type | Automated External Defibrillator |
| Waveform | Biphasic |
To Next Page