Physio Control LIFEPAK 500 - Transferring Setup between Aeds

Previous Page Table of Contents Section Contents
Back
Index Next Page
LIFEPAK 500 automated external defibrillator Modes of Operation
5-7
Transferring Setup Between AEDs
Transferring setup is a time-saving way to assign the same setup to more than
one LIFEPAK 500 AED. The sending and receiving AEDs must be of the same
key configuration (3-button or 2-button) and the same defibrillation waveform
configuration (monophasic or biphasic) and both must be either voice or non-
voice recording type units. To transfer the setup, click on Transfer Setup.
Note: The transfer setup option became available with version 4.2 LIFEPAK 500
Monophasic AED operating system software and is available with all versions of
the LIFEPAK 500 Biphasic AED operating system software.