LIFEPAK 500 automated external defibrillator Section Contents
Previous Page Table of Contents
Back
Index Next Page
12-1
Parts Lists and
Assembly
Diagrams
11
The Parts List and Assembly Diagrams section is a hierarchical reference for use
in identifying components needed to repair the LIFEPAK 500 AED. With the
introduction of the LIFEPAK 500 Biphasic AED, the part number scheme for
differentiating AED versions changes.
Page 1 of 2 Product Configuration
The Parts Configurator, which leads you to the replaceable parts that are
specific to your unit, controls LIFEPAK 500 AED final assemblies. Top level part
numbers (identified by six digits after the part number) indicate units controlled
under the Parts Configurator.
The Product Line History section lists the top-level part numbers of earlier-
version monophasic AEDs. These units are identified by three digits after the
part number.
Selecting a Service Kit part number jumps to a listing of all components
included in the kit.
Monophasic and Biphasic Assembly Parts are components used in all
versions of the AED. Use this table to locate components included in service kits
and other components that may not be part of a kit. Clicking on the component
part number jumps to a typical drawing view showing the part installed in an AED
final assembly.
Note: Final Assembly Parts are shown in a typical context but may appear
slightly different in your AED, depending on the configuration and options.
To Next Page
Loading...
