EasyManua.ls Logo

PIAGGIO Beverly 250 i.e. - Spark Plug Replacement

PIAGGIO Beverly 250 i.e.
84 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TYRES MUST BE REPLACED WHEN THE TREAD REACHES THE WEAR LIMITS
SET FORTH BY LAW.
Characteristic
Tyre pressure (front wheel)
Front wheel: 2.1 bar
Tyre pressure (rear wheel)
Rear wheel: 2.3 bar
Tyre pressure (rear wheel with rider and passenger)
Rear wheel (rider and passenger) 2.5 bar
03_08
Spark plug dismantlement (03_08, 03_09)
Proceed as follows:
1. Remove the access cover over the spark plug on the right-hand side of the scooter
and reach into the spark plug with your hand;
2. Disconnect spark plug HV wire cap «A» ;
3. Unscrew the spark plug using the spark plug wrench supplied;
4. When refitting, place the spark plug into the hole at the required angle and tighten
by hand until it is finger tight;
5. Use the wrench only for final tightening of the spark plug;
6. Place hood "A" fully over the spark plug.
39
3 Maintenance

Related product manuals