This section describes the general specifications of the vehicle.
Vehicle identification
The frame prefix «A» is stamped near the fuel
tank.
The engine prefix «B» is stamped near the rear left
shock absorber lower support.
VEHICLE IDENTIFICATION
Specification Desc./Quantity
Frame prefix ZAPTD1200
Engine prefix TD13M
Vehicle data
VEHICLE DATA
Specification Desc./Quantity
Frame In tubes and steel sheet metal
Front suspension Rolling system composed of a universal joint composed of alu-
minium rods and of two side tubes and shock absorbers with a
hydraulic lock system
Rear suspension Two double-acting shock absorbers, adjustable to four posi-
tions at pre-loading.
Front brake Dual 258 mm hydraulically operated disc brakes controlled
from RH handlebar lever; braking assisted by ABS system
(where available).
Rear brake Ø 240 mm hydraulically operated disc brake controlled from LH
handlebar lever; braking assisted by ABS system (where avail-
able).
Integral braking system A hydraulic system allowing the rider to operate all three brake
discs simultaneously from the pedal on the foot board; braking
assisted by ABS system (where available).
Wheel rims type Light alloy.
Front wheel rims 13" x 3.00
Rear rim 14'' x 4.00
Front tyres Tubeless 110/70 - 13" 48S
Technical Data MP3 400 hpe E5
DT - 18
To Next Page
Loading...
