Transponder Search
Check the transponder signal and search channels.
Select <Transponder Search> by using
CH+/–. Press OK to view the sub-menu
as shown in the following figure.
A. Sat name
To select <Sat name>, press VOL+. Select satellite by using CH+/– or
PGUP/PGDW, then press OK to confirm it.
B. Frequency
Select a valid transponder in the satellite or input the frequency (0-20000 MHz).
C. Polarization
Select the polarization of transponder between HOR and VER by using VOL+/–.
D. Symbol rate
Press numeric keys to enter your required value manually.
E. FEC (Forward Error Correction)
Select the FEC of transponder by using VOL+/–. Available options are Auto,
1/2, 2/3, 3/4, 5/6 and 7/8.
F. Network search
Select <YES> for a network search of the transponder.
Select <NO> to search only the transponder channels.
G. FTA Only
Select FTA Only <Yes> to search only free-to-air channels.
Select FTA Only <No> to search all channels.
H. Advanced Search
Press OK to enter the advanced search menu. Input the Video PID, Audio PID
and PCR PID to add a channel.
28
4.3 Installation Settings
MAIN MENU
To Next Page
Loading...