B. Delete
This command allows you to delete one or more satellites from the satellite list.
a. Select <Delete> by using VOL+/–.
b. Select a satellite you want to delete by using CH+/– or PGUP/PGDW.
c. Press
OK to view the sub-menu as shown in the following figure.
d. Select <Yes> by using
VOL+/–. Press OK to delete the satellite, or else
cancel the operation.
C. Rename
The Rename command lets you change the name of the satellite as it appears
in the satellite list. Select the satellite whose name needs to be modified by using
CH+/–. Press OK on the selected “Rename” command.
a. Select <Rename> by using
VOL+/–.
b. Select a satellite by using CH+/– or PGUP/PGDW. Press OK to view the
sub-menu as shown in the following figure.
30
4.3 Installation Settings
MAIN MENU
To Next Page
Loading...