D. Move
The Move command allows you to place a satellite in a different position on the
satellite list. After selecting this command, a small input box will appear on the
screen. Input a number between 1 and the total number of the existing satellites
by using
numeric keys on the remote control. After pressing OK, the selected
satellite will be moved to the new location specified by your input.
a. Select <Move> by using VOL+/–.
b. Select a satellite you want by using CH+/– or PGUP/PGDW.
c. Press
OK to view the sub-menu as shown in the following figure.
To move the satellite to a new position, press the
numeric keys, then press
OK to confirm it.
4.3 Installation Settings
31
MAIN MENU
To Next Page
Loading...