12
Customer support team: +44 (0) 333 220 6054
• Once the filter has been removed from
the unit, soak it in mild detergent for a
few minutes, then rinse it under cold
water and dry it with a soft cloth or
towel. Ensure the filter is thoroughly dry
before attempting to re-fit it into the unit.
• When the filter is fully clean, re-insert it
into its slot at the back of the unit.
Cleaning the Water Tank:
1. Before cleaning the water tank, remove it
from the unit as detailed in the ‘Using the
Water Tank’ section above.
2. Once the water tank has been detached
from the unit, clean it with a damp towel
and some mild detergent, to remove
limescale, then wash it with clean water.
3. When the tank is clean, pour the dirty
water out and leave it to dry. Ensur
e the
water tank is thoroughly dry before re-
fitting it into the unit.
4. When the water tank is fully dry, place it
back into its slot on the main body of the
unit and turn the locking knob counter-
clockwise 90 degrees to secure it int
o
place.
Storing the Appliance:
1. When not using the vacuum for extended
periods of time, store the unit in a cool,
dry place, preferably inside its original
packaging, and out of the reach of
children.
Note:
Always unplug the unit from the mains
before cleaning.
Clean the unit regularly to ensure optimal
performance.
Note:
To prevent the unit from running on dry,
the water pump will automatically stop
working after 10 hours of continuous
operation.
WARNING!
Do not allow water or any other liquid
into the motor housing or any of the inner
components, as this could cause damage
to the unit.
Note:
When filling up the tank, take care to
ensure the water level is between the
MIN and MAX lines. You can gauge the
water level at any time using the water
window at the front of the appliance.
Take care to ensure the water tank
is filled when attempting to use the
humidifying function. Refer to the ‘Using
the Water Tank’ section of this manual for
instructions on how to fill the water tank.
Once the water tank has been filled and
securely slotted back into place, press the
Humidifying button again to activate the
humidifying function.
To Next Page
Loading...
Need help?
General
