11
Controlling the Air Flow:
This unit allows for manual control of the
air flow through the positioning of the outer
louvers at the front of the unit.
1. To position the louvers, gently hold them
by the lip and push them upwards or
downwards as required to control the air
flow.
The Timer Function:
The unit is complete with a built-in digital
timer, allowing for pre-set cooling cycles of 1,
2, 4 or 8 hours.
1. Press the ‘Timer’ button on the remote
control or the unit’s control panel to
activate the timer function. The ‘1H’
indicator will show on the unit’s display
panel to indicate the timer function has
been activated.
2. Once the timer function is activated,
repeatedly press the ‘Timer’ button on
the remote control or the unit’s control
panel to cycle through the available
timers. The corresponding indicator will
light up on the unit’s display panel to
indicate each timer has been selected.
NOTE: The timer function operates in
ascending order only. To decrease the length
of the cooling cycle, repeatedly press the
‘Timer’ button on the remote control or the
unit’s control panel until a full cycle has been
completed and no indicators are lit up on the
unit’s display panel; then, repeatedly press this
button again until the corresponding length
of time has been selected. For example, to go
down from a 4 hour cooling cycle to a 2 hour
cooling cycle, press the ‘Timer’ button until the
timer has gone past the ‘8h’ setting and all the
indicators on the unit’s display panel are off,
then press it twice more until the ‘2h’ indicator
lights up.
Cleaning and Care:
Cleaning the Unit:
• Before cleaning always switch off the
appliance and remove the plug from the
electrical socket.
• To clean the outside of the fan, wipe
the exterior with a soft, damp cloth and
white soap. Use a dry cloth to polish it if
desired.
• Never use any abrasive cleaning materials
to clean the fan.
• When not in use, store the fan (preferably
in its original box) in a cool, clean and dry
location.
Warning! DO NOT allow water or steam to
enter any part of the appliance, as this could
cause it to malfunction.
Cleaning the Filter:
This unit is fitted with a removable filter, for
easy cleaning.
• To remove the filter from the unit, begin
by disconnecting the unit from the mains.
Once the unit has been unplugged, pull
the filter mesh out from its slot at the
back of the unit, as shown in the image
below.