36
have two that mount from the rear
of the firewall on the top of the
cowl and two that mount from the
front of the cowl opening
4. Ensue all the corner are rounded
and not sharp 90 degrees against
splitting under vibration. Trial fit till
the cowl is right
Maybe more exit air cooling
will be needed to allow for
depending on your engine’s
recommended running
temperature.Always check
your engine and Pilot-rc
dosen’t accept responsibility
for any damage from
improper engine cooling
NOTICE:
need an extension tool with a proper
size ball driver and handle by cutting
standard ball driver in half .Some
small heat shrink tubing are attached
to the ball driver to hold in place.You
have to reattach the cowl in the
future by this method
Crowl Assembly
To Next Page
Loading...
