Pima FORCE Series Installation Guide

FORCE Series Installation Guide
28 PIMA Electronic Systems
Parameter
Description
 Alarms and
Others
Set event and restore codes for the following events:
1) Panic and Fire alarms, Technician On-site , Invalid Code, Test.
2)  Tampers: Tamper 1-2 and Peripherals ’ Alarm and Restore codes.
7.1.3 Custom Zones Reports
System Configuration  CMS & Communications  Monitoring Stations  Custom Zones Reports
Set the ContactID (alarm and restore) codes, and SIA’s alarm and restore codes for the custom
zones. Custom zones are based on modified zone types that allow alarm reporting with any
ContactID or SIA code (other than the original zone type - Burglary, Panic, etc.).
Below is a list of more frequently used ContactID and SIA events, which can be used with the
custom zones.
Event
ContactID
SIA
Event
ContactID
SIA
Gas detected
151
GT
Low temp
159
ZA
Refrigeration
152
ZA
High Humidity
168
-
Loss of heat
153
ZA
Low Humidity
169
-
Water Leakage
154
WA
Low water pressure
201
WT
Low bottled gas level
157
GA
Low water level
204
WT
High temp
158
KA
7.2 PIMA Cloud
System Configuration  CMS & Communications  PIMA Cloud
Parameter
Description
 Network
(Ethernet)
 Cellular Data
1. Select the communication path of the cloud.
2. Do not change the default URL (force.pimalink.com) or IP address
(13000) for the selected path.
3. Set the Port to 0 for the other path.
 Main Path
Select if the cloud will be the main communication path. When cleared, this
path will backup the main path.
Only select one main path, or the communication
with the cloud will be unstable!
Do not change the default cloud URL, or the cloud service will be
unavailable. Consult with PIMA first when it is required.

Pima FORCE Series Specifications

General

Brand	Pima
Model	FORCE Series
Category	Security System
Language	English