Pima RX-406 - SYSTEM FUNCTIONS; To arm;disarm Partition #1; To arm;disarm Partition #2; To arm;disarm the entire Alarm System

RXN-406 Keypad for CAPTAIN-i - User Guide
7
S YSTEM F UNCTIONS
IMPORTANT!
The [ symbol indicates information that you must enter.
 To arm/disarm Partition #1: [User Code
 To arm/disarm Partition #2: [User Code
 To arm /disarm the entire Alarm System: [ Any User Code that
belongs to either partitions OR
[ Short Code.
NOTE:
 A user can arm/disarm only partitions allocated to him/her by the technician
(partitions #1, #2, or both).
 All keypads connected to the system share the same display, even if they are
allocated to different partitions.
IMPORTANT!
 Entering the Master Code + when one of the partitions is armed will
arm the other partition as well.
 Entering the Master Code + when both partitions are armed will disarm
the entire system.
 To arm the alarm system in HOME mode:
Press and hold
[ any User Code OR Short Code.
NOTES:
 Since CAPTAIN-i has only one HOME state, pressing either key 7 or 4 makes
no difference.
 When the FAULT LED is blinking and there is no other indication LED blinking
simultaneously, the fault is ‘Clock not set’.
To disarm the alarm system in HOME mode:
[ any User Code
 To bypass/re-arm a bypassed alarm zone:
[ Primary Code [ zone number [