Need help?Do you have a question about the Pima RX-406 and is the answer not in the manual?
Defines user access codes for system operation and programming.
Describes a convenient two-digit code for arming the system.
Explains the code for silent disarming and sending a duress alert.
Explains the green LED for system arming status and delay times.
Describes the red FAULT LED indicating system faults.
Details the six red LEDs indicating individual zone status (open/closed/alarm).
Lists specific LEDs for system status and faults like power, battery, and communication.
Instructions for arming and disarming the first partition.
Instructions for arming and disarming the second partition.
How to arm/disarm both partitions simultaneously.
Procedure for arming the system in HOME mode.
Procedure for disarming the system in HOME mode.
Steps to bypass or re-enable specific alarm zones.
Procedure to reset smoke or fire detectors after an event.
Method to view which zone(s) triggered the last alarm.
How to turn the keypad chime feature on or off.
Temporarily deactivates the entry delay countdown.
Instructions for reporting a duress event to the monitoring station.
Instructions for reporting a fire event to the monitoring station.
How to abort a programming sequence and restart.
Steps to set or change the primary access code.
Instructions to program the first user access code.
How to remove the first user access code.
Guide to program additional user codes from 2 to 8.
Steps to remove user access codes from 2 to 8.
Procedure to set a short code for system arming.
How to remove a previously programmed short code.
Setting the time for automatic system arming.
Disabling the automatic arming feature.
Entering phone numbers for dialer communication.
Removing all programmed telephone numbers.
Correctly setting the system's internal clock.
Configuring zones to activate keypad chime on entry.
To Next Page
General
