Listening to your system06
34
En
Chapter 6:
Listening to your system
Important
• Certain features explained in this section
will not be possible depending on the
source (for example, PCM 88.2 / 96kHz,
DTS 96kHz (24 bit) or WMA 9 Pro sources).
Auto playback
There are many ways to listen back to sources
using this receiver, but for the simplest, most
direct listening option is the Auto Surround
feature. With this, the receiver automatically
detects what kind of source you’re playing and
selects multichannel or stereo playback as
necessary.
1
• While listening to a source, press
STEREO for auto playback of a source.
Press repeatedly until
AUTO SURR.
shows
briefly in the display (it will then show the
decoding or playback format). Check the
digital format indicators in the display to see
how the source is being processed.
Listening in surround sound
Using this receiver, you can listen to any
source in surround sound. However, the
options available will depend on your speaker
setup and the type of source you’re listening to.
If you connected surround back speakers, see
also
Using the surround back channel
(Extended mode)
on page 39.
2
The following modes provide basic surround
sound for stereo and multichannel sources.
• While listening to a source, press
STANDARD.
If necessary, press repeatedly to select a
listening mode.
• If the source is Dolby Digital, DTS, or Dolby
Surround encoded, the proper decoding
format will automatically be selected and
shows in the display.
3
With two channel sources
, you can select from:
•
2
Pro Logic IIx MOVIE
– Up to 7.1
channel sound, especially suited to movie
sources
Note
1• Stereo surround (matrix) formats are decoded accordingly using
Neo:6 CINEMA
or
2
Pro Logic IIx MOVIE
(see
Listening
in surround sound
above for more on these decoding formats).
• The Auto Surround feature is canceled if you connect headphones or select the multichannel analog inputs.
RECEIVER CONTROL
SHIFT
LEVEL
SLEEP
STANDARD ADV.SURR
DIALOG E INPUT ATT
STEREO
MIDNIGHT/
LOUDNESS
EFFECT
/CH SEL
ACOUSTIC
EQ
2 If the Extended mode (page 39) is switched to
OFF
, or the surround back speakers are set to
NO
(this happens automatically
if the
Surround back speaker setting
on page 43 is set to anything but
SB NORM.
),
2
Pro Logic IIx
becomes
2
Pro Logic II
(5.1
channel sound).
3 If the Extended mode (page 39) is switched to
OFF
, or the surround back speakers are set to
NO
(page 42),
2
Pro Logic IIx
becomes
2
Pro Logic II
(5.1 channel sound).
RECEIVER CONTROL
SHIFT
LEVEL
SLEEP
STANDARD ADV.SURR
DIALOG E INPUT ATT
STEREO
MIDNIGHT/
LOUDNESS
EFFECT
/CH SEL
ACOUSTIC
EQ
VSX_815-915.book.fm 34 ページ ２００４年１２月８日 水曜日 午後４時３分
To Next Page
Loading...
Need help?
General
