Controlling the rest of your system03
16
En
Erasing one of the remote
control button settings
This erases one of the buttons you have
programmed and restores the button to the
factory default.
1 While pressing
MULTI OPERATION
, press
HOME MENU
.
The remote display shows SETUP MENU.
2Use
/
to select ‘
ERASE LEARNING
’,
then press
ENTER
.
The remote display prompts you for the
component corresponding to the button
setting to be erased.
3 Press the input function button
corresponding to the command to be erased,
then press
ENTER
.
The remote display flashes PRESS KEY.
4 Press and hold the button to be erased for
two seconds.
The remote display shows OK or NO CODE to
confirm the button has been erased.
5 Repeat step 4 to erase other buttons.
6 Press and hold
MULTI OPERATION
for a
couple of seconds when you’re done.
Resetting the input assignment
of one of the input function
buttons
This procedure resets the input assignment
preset at the remote control’s input function
button, restoring the default.
1 While pressing
MULTI OPERATION
, press
HOME MENU
.
The remote display shows SETUP MENU.
2Use
/
to select ‘
KEY RESET
’, then
press
ENTER
.
The remote display prompts you for the
component corresponding to the button
setting to be erased.
3 Press the input function button for the
component whose input assignment you
want to reset, then press and hold
ENTER
for
a couple of seconds.
The remote display shows OK when the input
assignment of the remote control’s input
function button is reset.
Resetting the remote control
settings
Use this procedure to reset all the remote
control’s settings to the factory default.
1
1 While pressing
MULTI OPERATION
, press
HOME MENU
.
The remote display shows SETUP MENU.
2Use
/
to select ‘
ALL RESET
’, then press
ENTER
.
ALL RESET flashes in the remote display.
3 Press and hold
ENTER for about two
seconds
.
The remote display shows OK to confirm the
remote presets have been erased.
Confirming preset codes
Use this feature to check which preset code is
assigned to an input function button.
1 While pressing
MULTI OPERATION
, press
HOME MENU
.
The remote display shows SETUP MENU.
2Use
/
to select ‘
READ PRESET ID
‘,
then press
ENTER
.
The remote display prompts you for the input
function button you want to check.
Note
1 When Selecting preset codes directly on page 14 are set, all the signals learned in the input function buttons are
cleared. This function is convenient when you want to reset some but not all of input function buttons.
CU-RF100.book Page 16 Wednesday, March 17, 2010 6:13 PM
To Next Page
Loading...
