Why are the VRs, such as equalizers, etc., defective on my Pioneer DJ Equipment?
Defective operation of VRs, such as equalizers, may occur if the positive voltage of the capacitor at Section F is not +3.3 V. Check that the voltage is correct.
What to do if the STBY LED does not light on Pioneer DJ Equipment?
If the STBY LED does not light and the product does not operate even after plugging in the AC power cord: 1. Check the voltage of V+5D_U power. 2. If the voltage does not become high, check conduction at the protector (P3002). 3. If the protector is intact, check each voltage on the MAIN Assy.
General| Sample rate | 48 kHz |
|---|---|
| Frequency range | 20 - 20000 Hz |
| Channels quantity | 2 channels |
| Digital sound processing | 24 bit |
| Number of EQ bands per channel | 3 |
| Line Signal-to-Noise Ratio (SNR) | 94 dB |
| Total Harmonic Distortion (THD) | 0.007 % |
| USB 2.0 ports quantity | 2 |
| Dimensions (WxDxH) | 218 x 301 x 107 mm |
| Power consumption (typical) | 17 W |
Weight and Dimensions| Weight | 3200 g |
|---|
Instructions to prevent electric shock and avoid opening the unit.
Warnings about water, flames, ventilation, and operating environment hazards.
Precautions for safe handling, maintenance, and use of the power cord.
Identification of all input and output terminals on the rear and front panels.
Core operations for DJ mixing, including channel controls and level adjustments.
Techniques for blending audio sources using channel faders and the crossfader.
A systematic approach to identifying and fixing operational problems.
Explanation of error codes indicated by the USB STOP light and their solutions.
To Next Page
