Section
(_c_o_n_n_e_c_ti_n~g_t_h_e_u_n_i_ts
__________________________
~)CIJ
About
bridged
mode
Diagram
A -
Proper
Pioneer
A
mp
lifier
4
Q
Bndged
Mode
Diagram
B -
Improper
L$
Pi
oneer
l\(nplifi~
r
2
Q
Bridged
Mode
Speaker impedance is max. 4
n,
please
carefully
check. Improper connection to the amplifier may
result
in
malfunction or personal injury due to
burns from overheating.
For
bridged mode for a two-channel amplifier,
with a 4
n
load, either wire two 8
n speakers in
parallel, Left
EB
and Right
8
(Diagram A) or use a
single 4
n
speaker.
For
other amplifiers, please
follow the speaker output connection diagram for
bridging shown
on
rear:
two 8
n speakers
in
par-
allel
for a 4
n
load
or a single 4
n
speaker per
channel.
For
any further enquiries, contact your local
authorized Pioneer dealer or customer
service.[!]
About
suitable
specification
of
speaker
Ensure speakers conform to the following
standards, otherwise there
is
a risk of fire,
smoke or damage. Speaker impedance is 2
n
to 8
n
for
stereo connection,
or
4
n
to 8
n for
monaural and other bridge connection.
Subwoofer
Two-channel output
Nominal input:
Min.
130W
One-channel output
Nominal input:
Min.
400W
Other
than
subwoofer
Tw
o-c
hannel output
MAX input:
Min.
25
0
W
On
e-channel
output
MAX input:
Min.
800W
Connecting
the
speakers
The speaker output mode can
be
two-channel
(stereo) or one-channel (mono).
Connect
the
speaker leads to suit the mode according
to
the figures shown below.
lWo-channel
output
(Stereo)
Q)
Speaker (left)
(?)
Speaker (Right)
One-channel
output
CD
Q)
Speaker
(Mono)[!]
En
CIJ
To Next Page
Loading...
Need help?
General
Weight and Dimensions
