3rd generation 43" PLASMA
Quick Reference Chart
PDP-433CMX PDP-4300 PRO800HDI PDP-433PU
PRO800HD
(2) AXY1056 or (7) 59 (7) AXY1059 (7) AXY1059 (2) AXY1056 or (7) 59
(7)AXX1064 (2201-15940)
' (0-3480) ' must check ' (2761-10130)
(7) must check
(3) New Scan IC S/N 5011 ALL ALL 3811
Service Panel Assy (2,3) AWU1069 AWU1069 AWU1069 (2,3) AWU1069
Digital Video Assy (3) AWV1941, 80 or 71 AWV1971 AWV2071 (3) AWV1929, 41, 80 or 71
Y Drive Assy (4) AWZ6683 or 6748 AWZ6748 ' (4) AWZ6683, 6708 or 49
X Drive Assy. (4) AWV1930 or 85 AWV1985 ' (4) AWV1930 or 85
(ADR)Resonance Assy (6) AWZ6682 or 6751 AWZ6751 ' (6) AWZ6682 or 6751
Sub Address A Assy AWZ6692 AWZ6692 ''
Sub Address B Assy
AWZ6693 AWZ6693 ''
AWZ6697
AWZ6744 (after # 4721)
I/O Assy AWZ6631 AWZ6631 AWZ6801 N/A
MR Interface Assy N/A N/A N/A AWZ6699* (1637)
Audio Amp Assy N/A N/A N/A AWZ6687
MX Audio Assy AWZ6644 AWZ6644 ' N/A
FAN Moto
AXM1040
XM1040 ' N/
Thermal Sensor Ass
AWZ6639, 96
WZ6696 '
WZ6660
(MX) LED Ass
AWZ6642
WZ6642 '
WZ6655
Control Ass
AWZ6633
WZ6633 ' N/
IR Ass
AWZ6643
WZ6643 '
WZ6658
(Side/Front) Key Ass
AWZ6637
WZ6637 '
WZ6656
Key Connector Ass
AWZ6695
WZ6695 '
WZ6657
ideo Card
AWV1906
07**
WV1907
WV206
N/
Slot Connector Ass
AWZ663
WZ663
' N/
Front Case Ass
AMB2712
MB2762
MB2809
MB272
Hex Hole Bolt SMZ80H400FZB N/
N/
N/
AC cord ADG1178 '
DG1208 '
Protect Panel Ass
AMR3303
MR3303 ''
Display Stand AMR326
N/
' PDK-TS01
Remote Control
AXD1459
66
XD146
XD1459 RRMCG1679CES
System Cable (PDP-R03U) N/
N/
N/
QCNW-6117CEZZ
Power Cord (PDP-R03U) N/
N/
N/
QACCDA007WJP
Service Manual
ARP3123
3127 & 3155
RP3155
62***
RP318
ARP3111 & 3143
Owner's Manual
RD1049, 52
ARB1548
RB1551
RB1560 TINS-7552CEZZ
(2) See bulletin SI-D03016A & 03026. AXY1059 replaces all, but must adjust if replacing old supply. Also adjust if panel replaced.
(3) See bulletin SI-D03025C. Use existing Dvid. Must use new with service panel. Scan Ics changed, SN755860PJ to SN755864APZP.
(4) See bulletin SI-D03041A. Use existing X or Y. If old to new must adjust.
(5) See bulletin SI-D03003. Use existing Addr. Reso & Sub Addr. If old to new, replace both.
(6) See bulletin SI-D03033. Improved caps and added insulator.
(7) See bulletin SI-D04048A, SI-PG04007. Mandatory upgrade (serial range where needed). Orange dot by serial #
indicates already done. AXX1064 is AXY1059-H. AXY1059-A thru G need replacing.
* See bulletin SI-D03004. Old part# was AWZ6654. Will need (2) screws PMZ26P080FZK for new board.
** AWV1907 for PRO & 4300. Will need Torx Driver #T10H to remove from PRO.
***ARP3162 has AWV1907 schematic.
N/A
Power Supply Module
RGB Assy
AWZ6744 AWZ6837