8.
Language menu
Antenna menu
1. Setting a language
1 Press a/b to select the desired language listed
on the screen.
2 Press SET/ENTER to enter the setting.
2. Setting the antenna mode
1 Press a/b to select “Air” or “Cable” on the screen.
2 Press SET/ENTER to enter the setting.
Searching TV channels
CH Search
Air 2
Initial auto installation
When you turn on the Plasma Display System for the first time, it will automatically memorize the broadcasting
channels where you live. Perform the following steps before you press TV a.
1. Insert the batteries into the remote control unit.
2. Connect the antenna cable to the Media Receiver.
3. Plug in the power cord to the wall outlet.
3. Automatic channel searching
Channel auto search makes the Plasma Display System
look for all channels viewable in the set area.
A
• If no channel is found, “No program found. Is antenna
connected properly?” displays. And the auto channel
search finishes.
• Channel search function is available for ANT-A only.
• ANT-B cannot perform channel search.
• You may need to manually add the CABLE Converter
output channel setting (fixed), when connecting the CABLE
Converter output signal to the B terminal (ANT/CABLE
75q) on the Media Receiver (Rear).
Language
English
Français
Español
Air/Cable
Air
Cable
To Next Page
Loading...
