Pioneer PE6000 Series - Main Circuit Terminals and Wiring

PE6000 User Manual Mechanical and Electrical Installation
11
2.1.2 Main Circuit Terminals and Wiring
1) Description of main circuit terminals of single-phase AC drive
Terminal Name Description
L1、L2
Single-phase power supply
input terminals
Connect to the single-phase 220 VAC power supply
（+）、（-）
Positive and negative Common DC bus input point
（+）、PB
Connecting terminals of
braking
Connect to a braking resistor
U、V、W
AC drive output terminals Connect to a three-phase motor
Grounding terminal Must be grounded
2) Description of main circuit terminals of three-phase AC drive
Terminal Name Description
R、S、T
Three-phase power supply
input terminals
Connect to the three-phase AC power supply
（+）、（-）
Positive and negative
terminals of DC bus
Common DC bus input point
Connect the external braking unit to the AC drive of
18.5 kW and above (220 V) and 37 kW and above
(other voltage classes).
（+）、PB
Connecting terminals of
braking resistor
Connect to the braking resistor for the AC drive of 15
kW and below (220 V) and 30 kW and below (other
voltage classes).
P、（+）
Connecting terminals of
external reactor
Connect to an external reactor.
U、V、W
AC drive output terminals Connect to a three-phase motor.
Grounding terminal Must be grounded.
Figure 2-2 analog jumper of main board
J3 AO1 outpu
t
Voltage and
Current
J4 A12 Input
Voltage and
Current
J5 485 terminal
matched
resistance