Pioneer PE6000 Series - Wiring Mode of the AC Drive Control Circuit; Description of Control Circuit Terminals

Mechanical and Electrical Installation PE6000 User Manual
12
2.1.3 Wiring Mode of the AC Drive Control Circuit
Figure 2-3 Wiring mode of the AC drive control circuit
§ Note: All PE6000 series AC drives have the same wiring mode. The figure here shows the
wiring of three-phase 380 V AC drive. ◎ indicates main circuit terminal, while ○ indicates control
circuit terminal.
2.1.4 Description of Control Circuit Terminals
Terminal Arrangement of Control Circuit Terminal is as below:
Figure 2-3 Terminal Arrangement of Control Circuit
Braking resistor
Three-
phase
power input
Multifunctional input terminal 1
Multifunctional input terminal 2
Multifunctional input terminal 3
Multifunctional input terminal 4
Analog input
485 terminal matched
resistance selection
Relay 1
output
High-speed
pulse output
Multifunctional open collector output
Multifunctional
dual polarity
open collector
output terminal
AO1 output
0
-
20V/0
-
20mA
AO1 voltage output or current output
based on selection using jumper J3 High-speed pulse input