Need help?Do you have a question about the Pioneer SR-202W and is the answer not in the manual?
Adds natural reverberation to audio signals using transistorized circuitry and a high-performance unit.
Allows reverberation time to be adjusted as desired with an easy-to-view indicator.
Enables simultaneous control of two tape recorders for recording, playback, and other operations.
Designed for easy operation and a neat, user-friendly appearance.
Procedure for setting the unit to the proper line voltage and selecting the correct fuse rating.
Instructions on how to replace a blown fuse in the unit.
Recommendations for placing the unit in a suitable environment, avoiding high temperature, humidity, and instability.
How to connect the SR-202W to an amplifier or receiver using input and output terminals.
Instructions for connecting the SR-202W to tape recorders via their recording and playback terminals.
How to turn the unit on by rotating the power switch clockwise.
Adjusts the reverberation time by turning the knob clockwise to increase its duration.
Selects how the reverberation effect is applied: to speaker sound, no effect, or recorded signal.
Selects the active tape recorder (A, B) or their combination (A-B, B-A) for operation.
Instructions to add a reverberation effect to the speaker sound by setting the mode selectors.
Guide for recording with reverberation applied only to the speaker sound, using tape recorder A or B.
Procedure for recording from one tape recorder to another, with reverberation added to speaker sound.
How to dub audio between tape recorders while applying reverberation to the speaker sound.
Instructions for adding reverberation to both the recorded signal and the speaker output.
How to avoid adding reverberation effects to either recorded or speaker sound.
Steps to turn off the unit and reset the amplifier/receiver for normal operation when not in use.
To Next Page
General
