Need help?Do you have a question about the Pioneer SX-580 and is the answer not in the manual?
General| Tuning Range | FM, MW |
|---|---|
| Damping Factor | 30 |
| Power Output | 20 watts per channel |
| Frequency Response | 20 Hz - 20 kHz |
| Input Sensitivity | 2.5mV (MM), 150mV (line) |
| Signal to Noise Ratio | 70dB (MM), 80dB (DIN), 80dB (line) |
| Speaker Load Impedance | 4-16 ohms |
Details power output, distortion, input sensitivity, and tone control specifications.
Covers sensitivity, quieting, S/N ratio, distortion, capture ratio, selectivity, and antenna input.
Specifies sensitivity and selectivity for the AM band.
Explains the stereo decoder IC PA1001-A and its features like pilot signal cancellation.
Covers the equalizer, power amplifier, output meter drive, and audio muting circuits.
Identifies front panel components and their part numbers.
Shows internal components visible from the front after panel removal.
Identifies components visible from the top of the unit.
Identifies rear panel connectors and components.
Instructions for adjusting the AM tuner section using test equipment.
Instructions for adjusting the FM tuner section and multiplex decoder.
Exploded view showing external components and their part numbers.
Exploded view showing internal components and their part numbers.
Detailed schematic diagrams for various sections of the receiver.
Details the tuner and AF assembly.
To Next Page
