Need help?Do you have a question about the Pioneer SX-990 and is the answer not in the manual?
General| Total Harmonic Distortion | 0.8% |
|---|---|
| Tuning Range | FM, MW |
| Frequency Response | 20 Hz to 20, 000 Hz |
| Signal to Noise Ratio | 75dB (MM) |
| Weight | 10.3kg |
| Input Sensitivity | 2.5 mV (MM) |
| Speaker Load Impedance | 4Ω to 16Ω |
| Semiconductors | 28 x transistors |
| Power Output | 28 watts per channel (8 ohms, 20-20, 000 Hz) |
Details FM tuner sensitivity, selectivity, and AM antenna reception.
Highlights FM MPX circuit, versatile circuitry, and included accessories.
Describes the aesthetic design of the front panel with its controls.
Explains how to select the correct line voltage and replace fuses.
General overview of connecting stereo components like turntables and tape decks.
Guidelines for setting up the system and optimizing the listening environment.
Covers indicator lamps, tuning knob, and signal/tuning meters.
Groups volume, bass, treble, balance, and loudness controls.
Encompasses switches for speaker selection, mode, muting, and tape monitoring.
Refers to headphone and microphone jacks on the front panel.
Guides on using tuning meters for radio reception and the FM stereo indicator.
Covers the main tuning knob and selector switch for program sources.
Explains bass control, treble, and headphone jack usage.
Explains treble, balance, and volume adjustments.
Describes switches for noise filtering, loudness, muting, and tape monitoring.
Details mode selection and microphone input.
Details various input/output terminals like Phono, AUX, Tape.
Specifies antenna input terminals and ground connections.
Covers DIN tape connector and AM/FM antenna terminals.
Details pre-amp, main-amp, center channel, and speaker outputs.
Covers switched/unswitched AC outlets and the AC power cord.
Detailed instructions for connecting speakers to output terminals.
Guides for FM and AM antenna setup and grounding.
Grounding advice and turntable connection procedures.
Instructions for connecting tape decks and cartridge players.
Guides for tuning FM and AM stations and optimizing reception.
Instructions for playing records/tapes and using the microphone.
Covers recording, playback, and monitoring tapes with a deck.
Guides on multi-amplifier, 3-D, and center channel systems.
Lists transistors, ICs, diodes, and audio section performance details.
Covers FM/AM tuner specs, power supply, dimensions, and weight.
Guides on identifying and fixing various types of noise during operation.
Troubleshooting power-on issues and audio howling.
Step-by-step instructions for FM alignment using test equipment.
Detailed steps for multiplex section alignment.
Detailed steps for AM section alignment.
Visual guide to components on the top of the unit.
Visual guide to components on the bottom of the unit.
Lists capacitors, resistors, coils, switches, and potentiometers.
Lists other parts like front panel elements and connectors.
Lists parts for the FM front end and FM IF units.
Lists specific coils, transformers, and compound parts.
Lists all components for the MPX unit.
Lists parts for the muting unit.
Lists parts for the indicator unit.
Lists all components for the AM tuner unit.
Lists parts for the head amp unit.
Lists capacitors and resistors for the control amp unit.
Lists resistors and transistors for the control amp unit.
Lists parts for the control unit.
Lists parts for the push switch units.
Lists capacitors for the main amp unit.
Lists resistors for the main amp unit.
Lists diodes, transistors, and potentiometers for the main amp unit.
Lists parts for the power supply unit.
Guides on how to string the dial cord for the tuning capacitor.
To Next Page
