Pioneer SX-950 Procedure

SX-950 ALIGNMENT PROCEDURES
9.1 AM SECTION
1. Set function switch to AM.
2. Connect AM signal generator through 1k-ohm
resistor to AM antenna terminal.
3. Set DUPLICATE switch to OFF and connect
an AC voltmeter to TAPE 1 REC jacks.
4. Set AM SG for 400Hz 30% modulation 100dB
output.
5. Set SX-950 dial indication and AM SG
frequency for 600kHz.
6. Adjust T8 core for maximum reading on AC
voltmeter.
7. Set SX-950 dial indication and AM SG
frequency for 1,400kHz.
8. Adjust TC5 for maximum reading on AC
voltmeter.
9. Set AM SG for 30dB output.
10. Set SX-950 dial indication and AM SG
frequency for 600kHz.
11. Adjust T7, T8 and bar antenna core for
maximum reading on AC voltmeter.
12. Set SX-950 dial indication and AM SG
frequency for 1,400kHz.
13. Adjust TC5, TC6 and TC7 for maximum
reading on AC voltmeter.
14. Repeat steps 10-13 to eliminate variations in
AC voltmeter readings.

Pioneer SX-950 Specifications

General

Total Harmonic Distortion	0.1%
Tuning Range	FM, MW
Damping Factor	30
Input Sensitivity	2.5mV (MM), 150mV (line)
Speaker Load Impedance	4Ω to 16Ω
Type	Stereo Receiver
Year	1976
Signal to Noise Ratio	95dB (line)
Power Output	85 watts per channel into 8Ω (stereo)